Connect your KODAK Portrait 3D printer to the Internet to perform regular updates to take full advantage of all its great and latest features.
An Internet connection is required to use our KODAK 3D Cloud (powered by 3D Printer OS) which allows remote management of your printer(s).
To learn more about Cloud printing, be sure to read our article Cloud printing.
Connecting
NOTE: We strongly recommend using a wired Ethernet connection. A wired connection will allow your printer to have an optimal connection to the KODAK Cloud.
If you are having any difficulties, please check out our connection troubleshooting guide.
Ethernet
- Connect an ethernet cable from your router/modem directly into the ethernet socket on the back of the KODAK Portrait 3D printer.
- Go to Setup > Connectivity > Info and verify that you're getting a valid IP address from your router/modem.
|
Wifi (2,4GHz)
- Go to Setup > Connectivity > WiFi.
- Select your router's SSID on the list and enter its password when asked.
- Go to Setup > Connectivity > Info and verify that you're getting a valid IP address from your router/modem.
|
Updating
Note: Both methods below require version 2.x.x to be installed.
Instructions how to upgrade from 1.x.x can be found here: smart3d.tech/v2-installing
warning |
Do not disconnect the printer from any network while updating. Make sure the internet connection is not using a firewall.
|
Online
- Make sure your printer is connected to the Internet.
- Go to Setup » Manual controls » Update » Via Internet.
- The printer will now let you know if there is an update available.
- If you are notified that there is an update without any version number, check your Internet connection.
- If you see reparable_update_error appear on the screen, check your Internet connection.
- If an update is available; Press Update.
- The printer will now start updating. Do not turn the printer off during this phase. After that, the updating process will run and the printer will reboot itself and you can start printing.
|
USB (offline)
Note: This guide is only suitable for users with software version 2.03.02 or older.
- Download the USB update (2.03.03).
- Unzip the zip file to the root of a formatted USB drive.
- Insert the USB drive into the Portrait with version 2.x.x installed.
- Go to Setup » Manual Controls » Update » USB Update.
|