Site Preparation
DO NOT INSTALL the Dryer where:
- Flammable gas or corrosive gas is generated
- The ambient temperature exceeds 30°C / 86°F
- The ambient temperature fluctuates violently
- There is direct sunlight
- There is excessive humidity and dust
- There are constant vibrations
|
The dimensions shown in the figure are the minimum clearance requirements.
Take measures to prevent the unit from falling in case of an earthquake, high impact, etc. as it could lead to personal injury.
|
Handling of the power cord
- Do not use the power cord if it is bundled or tangled
- Do not process, bend, wring, or stretch the power cord forcibly
- Do not put the power cord under or through an object
- Do not run the power cord next to the heating equipment
|
Lock the wheels
Once your unit is in place, lock the wheels to prevent it from moving.
Replacing the exterior silica cartridge
It is highly recommended to replace this cartridge after the drying cycle for the one that was on the inside, ensuring the silica used is always dry.
Make sure your filaments are not in contact with the central heating compartment during the drying cycle. This surface may get very hot and could cause the spool and its filament to melt.
|
 |
CAUTION: The central heating compartment may get hot. |
Keep the door closed
Wait for the onscreen notification once the drying cycle has been completed before opening the door.